ADEMCO VISTA 10 Instrukcja Konfiguracji Pobierz pdf (Strona 60)

VISTA-10SE Installation and Setup Guide

10-2

Panic Keys

There are three individual panic keys and/or, on some keypads, panic key pairs. If programmed, they can be used to manually initiate

alarms and send a report to the central station.

Each key (or key pair) can be individually programmed for 24-hour Silent, Audible, Personal, or Fire Emergency responses. The panic

function is activated when both keys of the appropriate key pair are pressed at the same time, or the appropriate lettered key is pressed

for at least 2 seconds.

OFF AWAY STAY

INSTANT

CODE CHIME

MAX TEST BYPASS

READY

PANIC

897

ARMED

READY

Shown above is a typical 2-line alpha keypad

with individual Panic keys (shown lettered).

The panic functions are identified by the

system as follows:

Keys Displayed as Zone

[A], or [1] & [

✱

] 95

[B], or [

✱

] & [#] 7

[C], or [3] & [#] 96

Notes:

• Keys [A], [B], [C] are not on all keypads.

• Key [D], if present, is not active here.

Important:

For the Silent Panic functions to be of practical value, the system must be connected to a central station.

4285/4286 VIP Module (if used)

Refer to the separate instructions supplied with the VIP Module for information concerning its operating procedures.

Relay Outputs

(if used)

If relay outputs are used, two keypad entries available to the user are included among the system operation choices (34 and 35) that

may be programmed (see

SECTION 6: Output Device Programming

). They can manually activate or deactivate the relay(s) for starting

or stopping some action, such as turning lights on or off, etc.

These keypad entries are:

Security Code + [#] + [7]

and

Security Code + [#] + [8]

NOTE:

The keypad entry that is used to Start/Stop the action, cannot also be used to Stop/Start it. The opposite action must either be

performed by the other keypad entry or by some other event or operation offered in

SECTION 6: Output Device Programming

Exit Error Alarm Displays

(if programmed)

2-Line Alpha Display

Fixed-Word Disp

lay

Meaning

CANCELED ALARM

A display of

CANCELED ALARM

and a zone indication appears if an

exit or interior zone contained a fault during closing at the time the exit delay

ended (e.g., exit door left open),

and the system was disarmed during the

subsequent entry delay time.

The alarm sounder and keypad sound

continuously, but stop when the system is disarmed. No message will be

transmitted to the central station.

EXIT ALARM EA

A display of

EXIT ALARM

and a zone indication will appear if an exit

or interior zone contained a fault during closing at the time the exit delay

ended,

and the system was NOT disarmed during the subsequent entry delay

time.

The alarm sounder and keypad sound continuously until the system is

disarmed (or timeout occurs). An "exit alarm" message is sent to the central

station.

The

EXIT ALARM

display, etc. also result if an alarm from an exit or interior

zone occurs within two minutes after the end of an exit delay.

NOTE:

To clear display in either of the two above cases, use a second OFF sequence (

CODE

plus

OFF

[1] key) to clear the display.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 79 80

Komentarze do niniejszej Instrukcji

Brak uwag

ADEMCO VISTA 10 Instrukcja Konfiguracji Strona 60

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa ADEMCO VISTA 10