ADEMCO VISTA 10 Instrukcja Konfiguracji Pobierz pdf (Strona 25)

4-1

SECTION 4

Data Field Programming

•••••••••••••••••••••••••••••••••••••••••••••••••

About Data Field Programming

The following pages list this control’s data fields in numerical order. Field numbers are listed in the left column, followed

by a “Title and Data Entries column, which lists the valid entries for each field. Experienced installers can simply follow

this column when programming the data fields. The “Explanation” column provides explanatory information and special

notes where applicable.

Use the blank programming form to record the data for this installation.

Programming Data Fields

Data field programming involves making the appropriate entries for each of the data fields.

Start Data Field programming by entering the Installer code + 8 + 0.

System Setup Fields

✱

20 –

✱

FIELD TITLE and DATA ENTRIES EXPLANATION

✱

Installer Code

Enter 4 digits, 0 - 9

The Installer Code is used to assign the 4-digit Master

Security Code. See "Master Code" in SECTION 10: System

Operation for procedure.

✱

Quick Arm Enable

0 = do not allow quick arm

1 = allow quick arm

If enabled, a user code is not needed to arm the system.

Instead, users can press the [#] followed by an arming key

to arm the system.

However, the user code is always needed to disarm the

system.

✱

RF Jam Option

0 = if no receiver is being used

2 = 5800 system receiver; no jam detection

4 = 5800 system receiver with jam detection

This option is enabled if a wireless receiver is used.

If enabled, a report is sent if the system detects an RF

jamming signal.

✱

Forced Bypass

0 = no forced bypass

1 = automatically bypass all faulted zones

All zones bypassed by this function will be displayed after

the bypass is initiated.

UL installations must be set to 0 (no forced bypass)

✱

RF House ID Code

00 = disable all wireless keypad usage

01-31 = House ID

The House ID identifies receivers and wireless keypads. If

a 5827 or 5827BD Wireless keypad or 5804BD Transmitter

is being used, a House ID code

must

be entered, and the

keypad should be set to the same House ID.

✱

Output Relay Module

0 = if no relay module will be used

3 = if a relay module is used

Enabled if a 4204 Relay Module (containing 4 Form C

relays) is used in the system.

✱

Access Code for VIP (Phone) Module

1-9 = first digit of access code

✱

or # = second digit of access code

(enter # +11 for “

∗

”, or # +12 for “#”)

You need to assign a 2-digit access code for the 4285/4286

VIP (Phone) Module, if used.

Example: If desired access code is 7

✱

, 7 is the first entry,

and [#] + 11 (for

✱

) is the second entry.

NOTE:

A “0” in either digit disables the phone module.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 79 80

Komentarze do niniejszej Instrukcji

Brak uwag

ADEMCO VISTA 10 Instrukcja Konfiguracji Strona 25

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa ADEMCO VISTA 10