ADEMCO VISTA 10 Instrukcja Konfiguracji Pobierz pdf (Strona 2)

RECOMMENDATIONS FOR PROPER PROTECTION

The Following Recommendations for the Location of Fire and Burglary Detection Devices

Help Provide Proper Coverage for the Protected Premises.

Recommendations for Smoke and Heat Detectors

With regard to the number and placement of smoke/heat detectors, we subscribe to the

recommendations contained in the National Fire Protection Association's (NFPA) Standard #72

noted below.

Early warning fire detection is best achieved by the installation of fire detection equipment in all

rooms and areas of the household as follows: For minimum protection, a smoke detector should

be installed outside of each separate sleeping area, and on each additional floor of a multi-floor

family living unit, including basements. The installation of smoke detectors in kitchens, attics

(finished or unfinished), or in garages is not normally recommended.

For maximum protection, the NFPA recommends that you install heat or smoke detectors in

the living room, dining room, bedroom(s), kitchen, hallway(s), attic, furnace room, utility and

storage rooms, basements and attached garages.

In addition, we recommend the following:

• Install a smoke detector inside every bedroom where a smoker sleeps.

• Install a smoke detector inside every bedroom where someone sleeps with the door partly or

completely closed. Smoke could be blocked by the closed door. Also, an alarm in the hallway

outside may not wake up the sleeper if the door is closed.

DINING

KITCHEN

BEDROOM

LIVING ROOM

BEDROOM

BDRM

DINING

LIVING ROOM

TV ROOM

KITCHEN

BEDROOM

LVNG RM

BASEMENT

KTCHN

CLOSED

DOOR

GARAGE

Smoke Detectors for Minimum Protection

Smoke Detectors for Additional Protection

Heat-Activated Detectors

floor_plan-V0

• Install a smoke detector inside bedrooms where

electrical appliances (such as portable heaters, air

conditioners, or humidifiers) are used.

• Install a smoke detector at both ends of a hallway if

the hallway is more than 40 feet (12 meters) long.

• Install smoke detectors in any room where an alarm

control is located, or in any room where alarm control

connections to an AC source or phone lines are made. If

detectors are not so located, a fire within the room

could prevent the control from reporting a fire or an

intrusion.

THIS CONTROL COMPLIES WITH NFPA

REQUIREMENTS FOR TEMPORAL PULSE

SOUNDING FOR FIRE NOTIFICATION

APPLIANCES.

Recommendations for Proper Intrusion Protection

For proper intrusion coverage, sensors should be located at every possible point of entry to a

home or commercial premises. This would include any skylights that may be present, and the

upper windows in a multi-level building.

In addition, we recommend that radio backup be used in a security system so that alarm signals can

still be sent to the alarm monitoring station in the event that the telephone lines are out of order

(alarm signals are normally sent over the phone lines, if connected to an alarm monitoring station).

1 2 3 4 5 6 7 ... 79 80

Komentarze do niniejszej Instrukcji

Brak uwag

ADEMCO VISTA 10 Instrukcja Konfiguracji Strona 2

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa ADEMCO VISTA 10