
VISTA-10SE Installation and Setup Guide
5–8
NOTE: Be sure to remove one of the serial number labels from the new transmitter and affix it over the old
serial number label in the ENROLLED TRANSMITTERS worksheet in the Programming Form.
To Enter and Duplicate Wireless Keys
If you pressed the [D] key previously (from the beginning of the
✱
58 mode) to enter and duplicate 5804 and/or 5804BD
wireless keys, the following screens appear:
PROMPT VALID ENTRIES EXPLANATION
TEMPLATE?
1 – 6 1
Template Number
1-3 = 5804 templates
4-6 = 5804BD templates
1.
2.
3.
✱
L 01 02 03 04
T 23 22 21 23
Template Display
4.
✱
.
5.
✱
Enter Start Zone
00 = QUIT 22
Example of zone
↑
suggested by
the
system. This indicates
that zones 22, 23, 24,
and 25 are available.
Start Zone Number
5a. T
6.
✱
you entered (a total
of four consecutive zones), the following screen is displayed.
INPUT S/N L
AXXX-XXXX –
Serial Number
[
✱
]
to continue
7. Enter the serial number of the wireless key or depress any
button to transmit from a wireless key.
8. Press [
✱
] to accept the serial number.
The system checks for a duplicate number.
If a duplicate exists, a long error beep will sound and the
serial number reverts back to all "Xs" allowing you to
reenter the serial number.
If necessary, press the [#] key to back up without saving,
and reenter the serial number.
Use the [A] key to move forward within the screen, and the
[B] key to move backward.
XMIT TO CONFIRM
PRESS
✱
TO SKIP
Confirm
If you entered “Yes” at the
SET TO CONFIRM?
prompt
previously (see first prompt following entry into the
✱
56
or
✱
58 Programming Mode), the display on the left
appears. Confirm serial and loop numbers by activating
the wireless key.
Komentarze do niniejszej Instrukcji