ADEMCO VISTA 10 Instrukcja Konfiguracji Pobierz pdf (Strona 30)

VISTA-10SE Installation and Setup Guide

4-6

If an exit or interior zone contains a fault as the exit delay ends

, the local bell and keypad sound

continuously.

a) If the subscriber then disarms the system before the ensuing ENTRY delay ends, no message is

transmitted to the central station, but a zone indication and "Canceled Alarm" or "CA" is displayed on

the keypad.

b) If the system is not disarmed before that entry delay ends, a special message indicating Exit Alarm is

sent to the central station and a zone indication and "Exit Alarm" or "EA" is displayed on the keypad.

For expanded or 4+2 reporting, a 2nd digit is sent, and is the same as the 2nd digit of the zone Alarm

Report code programmed in field

✱

56.

For Contact ID

reporting, Event code 374 and the zone number is sent.

There is no restore message for an Exit Alarm report.

FIELD TITLE and DATA ENTRIES EXPLANATION

✱

Away/Stay Close Report Code

0 = no report

For both digits: 1-9, A-F (Refer to table on

for method of programming

report codes.)

This is a 2-digit entry field.

This option allows for programming of AWAY and STAY

reports.

✱

RF Xmtr LOW BAT Report Code

0 = no report

For both digits: 1-9, A-F (Refer to table on

for method of programming

report codes.)

This is a 2-digit entry field.

This is sent in the event that a wireless transmitter low

battery condition exists.

✱

Cancel Report Code

0 = no report

For both digits: 1-9, A-F (Refer to table on

for method of programming

report codes.)

This is a 2-digit entry field.

This is sent upon disarming of the system after an alarm

condition was reported.

RESTORE REPORT CODES (

✱

70 –

✱

75)

✱

Alarm Restore Report Code

0 = no report

For both digits: 1-9, A-F (Refer to table on

for method of programming

report codes.)

This is a 2-digit entry field.

This is sent upon disarming of the system after an alarm

condition was reported.

✱

Trouble Restore Report Code

0 = no report

For both digits: 1-9, A-F (Refer to table on

for method of programming

report codes.)

This is a 2-digit entry field.

This is sent when a trouble in a zone is restored.

✱

Bypass Restore Report Code

0 = no report

For both digits: 1-9, A-F (Refer to table on

for method of programming

report codes.)

This is a 2-digit entry field.

This is sent when a zone that has been bypassed is

unbypassed.

✱

AC Restore Report Code

0 = no report

For both digits: 1-9, A-F (Refer to table on

for method of programming

report codes.)

This is a 2-digit entry field.

This is sent when AC power has been restored after an AC

power outage.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 79 80

Komentarze do niniejszej Instrukcji

Brak uwag

ADEMCO VISTA 10 Instrukcja Konfiguracji Strona 30

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa ADEMCO VISTA 10