ADEMCO Security System VISTA-15CN Instrukcja Konfiguracji Strona 110

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 109
VISTA-15/VISTA-15CN Installation and Setup Guide
22–6
Setting the Real-Time Clock
General Information
This system provides a real-time clock that must be set in order for the system's event log to
keep track of events by time and date.
Use a 6139 Alpha Keypad to set the real-time clock, or set the clock via the downloader
software.
Only users with Installer or Master authority level can set the real-time clock.
In the event that
both
sources of power (AC and Battery backup) are lost, it is necessary to
reprogram the Real Time Clock.
Setting the Time and Date
1.
Enter
[4-digit Installer or Master code] + [#[ + [6] + [3[.
The alpha keypad indicates the following:
TIME/DATE FRI
12:00AM 01/01/99
The above display disappears in one minute if no entries are made or if the [#] key is
pressed. If this happens and you still want to make changes, repeat step 1.
2.
Press the [
] key to change the Date/Time setting. The display reverts to the following:
TIME/DATE FRI
12:00A1999/01/01
3.
The blinking cursor appears on the first digit of the hour to begin. Enter the time (hour,
then minute). After each entry, the cursor moves to the right.
4.
Press any odd-digit key for PM, or any even-digit key for AM.
5.
Enter the 4-digit year, the 2-digit month, and the 2-digit date, in sequence. The day of
the week is automatically calculated and displayed based on the date entered.
6.
Look over the display to make sure it is correct. To change incorrect information, press
the [#] key, which moves the cursor one space to the left, until the cursor sits on the
improper entry. Then press the correct key(s).
7.
Press the [
] key until the cursor is at the far right position.
8.
To accept all of the clock information, press the [
] key again. The top display appears.
9.
Exit clock mode by pressing the [#] key.
Przeglądanie stron 109
1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 131 132

Komentarze do niniejszej Instrukcji

Brak uwag