ADEMCO VISTA-128B Instrukcja Konfiguracji Pobierz pdf (Strona 62)

VISTA-128B Installation Instructions

8-8

Checkout Procedure for Wireless Zones

Transmitter ID Sniffer Mode

Use the Transmitter Sniffer Mode to test that transmitters have all been properly

programmed.

1. Enter [Installer Code] + [#] [3]. The keypad will display all zone numbers of wireless

units programmed into the system.

2. Fault each wireless zone, causing each device to transmit. As the system receives a

signal from each of the transmitters, the zone number of that transmitter will disappear

from the display.

A transmitter not "enrolled" will not turn off its zone number.

3. To exit the Transmitter Sniffer Mode, enter the [Installer Code] + [1] OFF.

Go/No Go Test Mode

Before mounting transmitters permanently, conduct Go/No Go Tests to verify adequate

signal strength and reorient or relocate transmitters if necessary.

Make sure that all partitions are disarmed when performing this test. Since the wireless

receiver gain is reduced, checking in this mode assists in determining good mounting

locations for the transmitters, and verifies that the RF transmission has sufficient signal

amplitude margin for the installed system.

1. Enter [Installer Code] + [5] TEST.

Note: For multi-partition systems, make sure all partitions are disarmed before entering

this mode.

2. Once transmitters are placed in their desired locations and the approximate length of

wire to be run to sensors is connected to the transmitter's screw terminals, fault each

transmitter.

Note: Do not conduct this test with your hand wrapped around the transmitter, as this will

cause inaccurate results.

• If a single receiver is used, the keypad will beep three times to indicate signal

reception. If two receivers are used, the keypad will beep once if the first receiver

received the signal, twice if the second receiver received the signal, and three times if

both receivers heard the signal (which is desirable for redundant configurations).

• If the keypad does not beep, reorient or move the transmitter to another location.

Usually a few inches in either direction is all that is required.

3. Mount the transmitter according to the instructions provided with the transmitter.

4. Exit the mode by entering [Installer Code] + [1] OFF.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 251 252

Brak uwag

ADEMCO VISTA-128B Instrukcja Konfiguracji Strona 62