ADEMCO VISTA-128B Instrukcja Konfiguracji Strona 165

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 252
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 164
Section 23 - #93 Menu Mode Programming
23-27
Relay Output Devices Programming
From Data Field Programming Mode, press #93 to display the "ZONE PROG?" prompt.
Press 0 (NO) to each menu option until the "RELAY PROG?" prompt appears. Press 1
(YES).
While in this mode, press [] to advance to next screen. Press [#] to backup to the previous
screen.
ENTER RELAY NO.
(00=QUIT) 01
Enter the relay (output device) identification number 01-16.
This is a reference number only, used for identification
purposes. The actual module address and relay number on the
module are programmed in the last two prompts.
Press [] to continue.
02 A EV ZL ZT P
STT 0 0 0 00
Press [] to continue.
02 A ZL ZT P
STP 0 0 00
The keypad will display a summary STOP screen.
Press [] to continue.
02 RELAY ACTION
NO RESPONSE
The Relay Action is the way in which the relay will respond
when activated by the "start" event. Enter the desired action
for this relay as follows:
0=not used; 1=close for 2 secs.; 2=stay closed; 3=pulse on/off;
4= toggle on and off alternately
02 START EVENT
NOT USED
A relay may be activated either by an Event used in
conjunction with a Zone List, and/or by a Zone Type/System
Operation. If using an Event/Zone List combination, enter the
event code as follows:
0=not used; 1=alarm; 2=fault; 3=trouble
If not using a Zone List to activate the relay, enter 0.
Press [] to continue.
02 START: ZN LIST
NO LIST
A Zone List is a set of zones that can be used to initiate the
start or stop relay action. If a zone list is being used to start
this relay action, enter the Zone List number 1-8. If a zone list
is not being used, enter 0.
Press [] to continue.
02 START: ZN TYPE
A Zone Type/System Operation can be used instead of or in
addition to an Event/Zone List combination to start the relay
action. If a Zone Type/System Operation is being used, enter
the 2-digit code as listed below.
Press [] to continue.
Przeglądanie stron 164
1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 251 252

Komentarze do niniejszej Instrukcji

Brak uwag