ADEMCO VISTA-128B Instrukcja Konfiguracji Pobierz pdf (Strona 217)

Section 28 - User Access Codes

28-7

To Add an RF Key to an Existing User

To add an RF key to an existing user, or to change a user's global arm option, first delete that

user's code, then re-add the user code as described in the "

To ADD a Master, Manager, or

Operator Code

" paragraph.

To Delete a Master, Manager, or Operator Code

Enter [your code]* + 8 + [User number (002-150)] + [your code again]

* Installer, Master or Manager Code, but must be code with higher level of authority than

the code being deleted (i.e. Master Code can delete a Manager or Operator-level Code, but

cannot delete another Master Code; a Manager Code can delete an Operator-level Code, but

cannot delete a Master or another Manager Code).

OK TO DELETE 003?

0=NO 1=YES

The system will prompt to confirm that you want to delete this

user. Press 0 (NO) or 1 (YES).

If “yes”, that user's code will be removed from all partitions to

which it was assigned, and all authorization levels and other

information about that user will be deleted. Note that a user

can only be deleted by a user with a higher authority level. A

user cannot delete himself.

A user code can only be deleted from the partition through which it was entered. If trying to delete

from another partition, the message "User [XXX] Not Deleted" will be displayed.

To EXIT the User Edit Mode

Press either [✴] or [#], or don't press any key for 10 seconds.

1 2 ... 212 213 214 215 216 217 218 219 220 221 222 ... 251 252

Brak uwag

ADEMCO VISTA-128B Instrukcja Konfiguracji Strona 217