ADEMCO VISTA-128B Instrukcja Konfiguracji Pobierz pdf (Strona 149)

Section 23 - #93 Menu Mode Programming

23-11

010 INPUT S/N

A 022-4064

↑

Serial #

The system will enroll the first serial number heard, display

the serial numbers, and cause the keypad to beep twice.

If the serial and loop number combination is already present in the system, the keypad will sound a

single long beep and display the word "DUPLICATE" along with the serial number, and the number

of the zone containing the serial/loop number combination.

The system will then enter an optional confirmation mode so that the operation of the actual

programmed input can be confirmed. Activate the loop input or button that corresponds to

this zone.

We recommend that you confirm the programming of every device before

proceeding to the next zone.

010 CONFIRMED SL:1

A022-4064

When the system sees activity on the appropriate input, it will

beep three times and display the confirmation message. Press

[

∗

]

or the upper left-hand button of the program tool when you

are ready to enroll the next serial number device.

At any time during this step, you may press

[

∗

]

on the keypad or the upper left-hand button of the

program tool if you are satisfied with the serial and loop number combination that has been

enrolled, regardless of whether or not the enrolled input has been "confirmed." This will ready the

system to enroll the next serial number device.

If the incorrect device has been enrolled, press [#] on the keypad or the upper right-hand button of

the program tool to delete the serial number and return to the "LEARN S/N?" prompt. A single long

beep will be heard from the keypad to verify pressing of the upper right-hand button. Then, press

(Yes) or press the upper left-hand button of the program tool (a single short beep will verify the

system is ready for enrolling) and re-activate the proper device or device loop input.

The system will search for the next zone that does not have a serial number associated with

it. If one is found, the system will return to the “INPUT S/N” prompt for the remaining

zones.

After all zones have been displayed, whether enrolled or not, the "ENTER ZN NO." prompt

will appear. Enter

000

to exit the Sequential Mode and return to Data Field Programming

Mode.

When you have finished programming all zones, test each using the system's Test Mode. Do not

use the Transmitter ID Sniffer Mode for this, as it will only check for transmission of one zone on a

particular transmitter, NOT the zones assigned to each additional loop, and will NOT verify polling

loop type.

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 251 252

Komentarze do niniejszej Instrukcji

Brak uwag

ADEMCO VISTA-128B Instrukcja Konfiguracji Strona 149

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa ADEMCO VISTA-128B