ADEMCO VISTA-128B Instrukcja Konfiguracji Pobierz pdf (Strona 215)

Section 28 - User Access Codes

28-5

To ADD a Master, Manager, or Operator Code

During user code entry, normal key depressions at other keypads in a partition will be ignored.

However, panic key depression will cause an alarm and terminate user entry.

Enter [Installer Code]

†

+ 8 + [new user # (002-150)] + [new user's code]

†

Or Master or Manager Code, but must be code with higher level of authority than the code

being changed (i.e., Master Code can add a Manager or Operator-level Code, but cannot add

another Master Code; a Manager Code can add an Operator-level Code, but cannot add a

Master or another Manager Code).

Keypad will prompt for the authority level for this user.

User Number = 003

Enter Auth. Level

Enter the level number as follows:

1 = Master (arm, disarm, bypass, add or modify lower-level

users)

2 = Manager (arm, disarm, bypass, add or modify lower level

users)

3 = Operator Level A (arm, disarm, bypass)

4 = Operator Level B (arm, disarm)

5 = Operator Level C (arm, disarm only if system armed with

this code)

6 = Duress (arm, disarm, trigger silent panic alarm)

Keypad will then prompt for Open/Close reporting option for

this user.

Open/Close Rep.?

0 = NO , 1 = YES

Press 0 (NO) or 1 (YES), depending on whether or not

arming/disarming by this user will trigger Opening and Closing

reports. This prompt appears only if the Installer Code is used

to add a user.

Access Group?

Enter 0-8

If access schedules have been programmed, this prompt

appears. Enter the user's access group number (1-8) if this user

should have limited access to the system. Enter 0 if no access

group should be assigned.

RF Button ?

0=NO , 1=YES

If a 5800 Series button transmitter has been enabled for

arming/disarming functions, and is not assigned to a user, this

prompt will appear. Press 0 (NO) or 1 (YES).

Enter Button ZN #

(001-087)

If “yes” was given as the answer to the RF button question, the

zone number for the button will be requested. Enter any one of

the zone numbers assigned to the button transmitter as AWAY,

STAY or DISARM. The system will then assign all buttons of

the transmitter to this user number.

1 2 ... 210 211 212 213 214 215 216 217 218 219 220 ... 251 252

Komentarze do niniejszej Instrukcji

Brak uwag

ADEMCO VISTA-128B Instrukcja Konfiguracji Strona 215

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa ADEMCO VISTA-128B