ADEMCO Vista AT Podręcznik Użytkownika Pobierz pdf (Strona 4)

– 4 –

Burglary System Features

Basic Features

Partitions • Partitions provide two independent areas of protection, with each partition containing a

group of zones that can be armed and disarmed without affecting other zones or users.

• Partitioned systems can include a common area, which is an area shared by users of two

other partitions (such as a lobby in a building).

• Some users may be given the authority to view status and arm/disarm other partitions.

• See Accessing Other Partitions section for details.

Zones • Each partition consists of specific protection points known as zones.

• When a zone is faulted, its zone number is displayed on the keypad for easy identification.

Keypads • The system is controlled from the keypad, and the keypad displays system status.

• Each keypad is assigned a default partition for display purposes, and will show only that

partition's information.

• When entering codes and commands, sequential key depressions must be made within 4-5

seconds of one another. If 4-5 seconds elapse without a key depression, the entry will be

aborted and must be repeated from its beginning.

• If you make a mistake while entering a security code, stop, press the [∗] key, and then start

over. If you stop in the middle while entering a code, and then immediately start the entry

over, an erroneous code might be entered.

Keypad Lockout: The system may have been programmed to lockout the keypads for 15

minutes if more than 30 keystrokes (within a 15 minute period) are made without a valid

user code plus command being entered. The message “Code Sabotage” is displayed during

the lockout period.

Voice Keypads • Voice Keypads (if installed), are functionally the same as other keypads.

• Voice announcements of system status (see Before Arming section)

• Voice chime, which can alert you to the opening of doors and windows while the system is

disarmed (see Voice Chime in Chime mode section)

• Message center, which lets you record and playback messages (see Using the Voice Message

Center in the System Overview section).

Security Codes • Your installer assigned you a security code at the time of installation. This code is required

to perform most system functions.

• Each security code can have a different authority level, which defines the functions each use

can perform. Refer to the Security Code section for details on adding and changing securit

codes.

Arm/Disarm • You can arm your system in several different modes, depending on whether you are staying

in or leaving the premises.

• To arm the system, simply enter your security code followed by the desired arming mode

key.

• To disarm the system, enter your security code followed by [1] OFF.

• Refer to the Arming/Disarming sections for specific arming commands.

1 2 3 4 5 6 7 8 9 ... 31 32

Brak uwag

ADEMCO Vista AT Podręcznik Użytkownika Strona 4