ADEMCO Vista AT Podręcznik Użytkownika Pobierz pdf (Strona 22)

– 22 –

Trouble Conditions

"Check" and

"Battery" Displays

* Not all systems

use wireless

sensors.

The word CHECK on the keypad's display, accompanied by a "beeping" at the

keypad, indicates a trouble condition in the system.

To silence the beeping for these conditions, press any key.

• "CHECK" and one or more zone numbers indicates that a problem exists with the

displayed zone(s) and requires your attention. Determine if the zone(s) displayed

are intact and make them so if they are not. If the problem has been corrected, the

display can be cleared if you enter the OFF sequence (security code plus OFF key)

twice. If the display persists, CALL FOR SERVICE.

NOTE: CHECK

70 on Fixed-Word/Icon Display keypads indicates that the

wiring connection to the external sounder is faulted (opened or shorted), and you

should CALL FOR SERVICE. See “BELL FAILURE” on next page. A display of

CHECK 90 indicates that RF interference may be preventing the operation of

wireless sensors* in the system. See “Rcvr Jam” on next page.

• If there are wireless sensors* in your system, the CHECK condition may also be

caused by some change in the environment that prevents the wireless receiver

from receiving communication from a particular sensor. CALL FOR SERVICE if

this occurs.

Other Trouble Displays

Words or letters in

parentheses ( ) are those

that are displayed on Fixed-

Word/Icon Display keypads.

* Any “beeping” that

accompanies a trouble

display can be stopped

by depressing any key

on the keypad or by

entering an OFF

sequence (code + OFF)

** Not all systems use

wireless sensors.

COMM. FAILURE Indicates that a failure has occurred in the

telephone communication

(or FC) portion of your system. CALL FOR SERVICE.

SYSTEM LO BAT Indicates that a low system battery condition

exists. Display is

(or BAT

with no accompanied by "beeping"* at the keypad.

Depending on installer

zone No.) programming, a system low battery may prevent

arming, or you may need to perform the arming

sequence twice to override the condition (see your

installer). If this condition persists for more than

one day (with AC present), CALL FOR SERVICE.

Tamper If programmed, indicates a tamper fault condition

(e.g., cover removed)

+ 1 + device number exists at the device shown.

LO BAT Indicates that there is a low battery condition in the

wireless

+ zone descriptor transmitter** number displayed (00 is RF keypad).

(or BAT

with Accompanied by a single "beep"

(once every 40

seconds) at the keypad.

zone No.) Either replace the battery yourself, or CALL FOR

SERVICE. If the battery is not replaced within 30

days, a CHECK display may occur indicating that

the transmitter is no longer operating.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Komentarze do niniejszej Instrukcji

Brak uwag

ADEMCO Vista AT Podręcznik Użytkownika Strona 22

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa ADEMCO Vista AT