ADEMCO VIA 30+ Instrukcja Naprawy Pobierz pdf (Strona 80)

15–6

Press

✱

62 AC LOSS REPORT CODE

Reports with Subscriber No. Timing of this report is random with

up to a 48-minute delay. The Restore report has a random delay

of up to about 12 minutes. If AC restores before the report goes

out, there is no AC restore report.

Press

✱

63 LOW BAT REPORT CODE

This will be sent when a low battery condition exists in the

system’s standby battery (connection to the standby battery is

checked every 3 minutes (CSFM requirement)).

Press

✱

64 TEST REPORT CODE

This is sent periodically to test that the communicator and phone

lines are operational (frequency of report is selected in field

✱

51).

Press

✱

65 OPEN/EXIT ALARM REPORT CODE, 1st DIGITS

Open Report Code : To enable, enter a code (or 0 to disable) in

the left-hand box.

For expanded or 4+2 reporting,

2nd digit = User #.

Exit Alarm Report Code: To enable, enter a code (or 0 to

disable) in the right-hand box. If enabled, any alarm from an

exit or interior zone occurring within two minutes after the

end of the exit delay will send a special message indicating exit

alarm to the central station, and a zone indication and "Exit

Alarm" or "EA" is displayed on the keypad.

If an exit or interior zone contains a fault as the exit delay

ends, the local bell and keypad sound continuously.

If the subscriber then disarms the system before the ensuing

ENTRY delay ends

, no message is transmitted to the central

station, but a zone indication and "Canceled Alarm" or "CA" is

displayed on the keypad.

If the system is not disarmed before that entry delay ends

, a

special message indicating Exit Alarm is sent to the central

station and a zone indication and "Exit Alarm" or "EA" is displayed

on the keypad.

For expanded or 4+2 reporting

, a 2nd digit is sent, and is the

same as the 2nd digit of the zone alarm report code programmed

in field ✱56.

For Contact ID reporting

, Event code 374 and the zone number is

sent.

There is no restore message for an Exit Alarm report.

Press

✱

66 ARM AWAY/STAY REPORT CODES

This option allows for independent programming of AWAY and

STAY reports . 2nd digit of Report is User No., if expanded or 4+2

reporting is selected.

Press

✱

67 RF XMTR. LOW BATTERY REPORT CODE

This is sent in the event that a wireless transmitter low battery

condition exists.

Press

✱

68 CANCEL REPORT CODE

This is sent upon disarming of the system after an alarm condition

was reported.

Press

✱

70 ALARM RESTORE REPORT CODE, 1st DIGIT

This is sent when the zone that caused an alarm is restored to its

non-faulted condition. 2nd digit is automatically sent as the 2nd

digit of the zone alarm report code programmed in field

✱

56, if

expanded or 4+2 reporting is selected.

Press

✱

71 TROUBLE RESTORE REPORT CODE

This is sent when a trouble in a zone is restored.

Press

✱

72 BYPASS RESTORE REPORT CODE

This is sent when a zone that has been bypassed is un-bypassed.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 103 104

Komentarze do niniejszej Instrukcji

Brak uwag

ADEMCO VIA 30+ Instrukcja Naprawy Strona 80

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa ADEMCO VIA 30+