ADEMCO VIA 30+ Instrukcja Naprawy Pobierz pdf (Strona 13)

2 –3

Installing the Control and RF Receiver Circuit Boards Together in the Cabinet

1. Hang two

short

(black) mounting clips (provided with receiver) on the

raised cabinet tabs, as shown in Detail B in Figure 3.

2. Insert the top of the receiver board (removed from its own case as de-

scribed in

its

instructions) into the slots at the top of the cabinet, as shown

in Detail A in Figure 3. Make sure that the board rests on the correct row of

tabs, as shown.

3. Swing the base of the board into the mounting clips and secure it to the

cabinet with the accompanying screws (see Detail B in Fig. 3).

4. Insert the top of the control's board into the slot in the clips and position

two

long

(red) clips at the lower edge of the board (see Detail C).

5. Swing this board into place and secure it with two additional screws.

6. Insert grounding lugs (supplied with the receiver) through the top of the

cabinet into the

left-hand

terminals of the antenna blocks (at the upper

edge of the receiver board) and secure them to the cabinet top with the

screws provided, as shown in Detail D.

7. Insert the receiver's antennas through the top of the cabinet, into the

blocks'

right-hand

terminals, and tighten the screws.

8. Setup and wiring of the receiver. is contained in the WIRELESS (RF)

ZONE EXPANSION (5700 & 5800 RF SYSTEMS) section.

Standard Phone Line Connections

The wiring connections shown here are not applicable if the 4285 Phone

module is used. Refer to the 4285 Phone module section for information

regarding phone line connections, which are different than those shown here.

Incoming phone line and handset wiring is connected to the main terminal

block (via a RJ31X jack) as indicated below and shown in Figure 4.

Term. 17: Local Handset (TIP – Brown*).

Term. 18: Local Handset (RING – Gray*).

Term. 19: Incoming Phone Line (TIP – Green*).

Term. 20: Incoming Phone Line (RING – Red*).

* Colors of wires in Direct Connect Cord.

TERMINALS

ON CONTROL

EARTH GROUND

➡

PREMISES

PHONES

Handset

Incoming

Telco Line

TIP

RING

BROWN (TIP)

GRAY (RING)

GREEN (TIP)

RED (RING)

RJ31X

JACK

PLUG

DIRECT

CONNECT

CORD

➧

TIP

RING

GROUND

▲

▲▲

INCOMING TELCO LINE

▲

{

17 18 19 20 21

Figure 4. Standard Telephone Line Connections

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 103 104

Komentarze do niniejszej Instrukcji

Brak uwag

ADEMCO VIA 30+ Instrukcja Naprawy Strona 13

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa ADEMCO VIA 30+