ADEMCO VISTA-250FBP Instrukcja Konfiguracji Pobierz pdf (Strona 32)

– 32 –

Device Programming

This menu is used to program keypads, receivers, and relay modules, etc.

Device Address 00 is always set as an alpha keypad assigned to Partition 1 with no sounder suppression

options, and these settings cannot be changed.

From Data Field Programming mode, press #93 to display "ZONE PROG?" Press [0] repeatedly to display "DEVICE PROG?"

PROMPT

EXPLANATION

DEVICE PROG?

1=YES 0=NO 0

Press [1] to enter

Device Programming

DEVICE ADDRESS

01-30, 00=QUIT 01

The device address identifies the device to the control. Enter the 2-digit device address number to match

the device's physical address setting (01-30).

Press [✱] to accept entry.

Select the type of addressable device as follows:

00 = device not used 05 = Do Not Use

01 = alpha keypad (6160/6160CR-2) 06 = communicator

03 = RF receiver (5881) 09 = Do Not Use

04 = output relay module (4204) 10 = Do Not Use

DEVICE TYPE

Press [✱] to accept entry.

Alpha Keypad

PROMPT

EXPLANATION

01 CONSOLE PART.

If you selected device type 01 (alpha keypad), this prompt appears. Enter the addressable device's default

partition number (01 to maximum number of partitions programmed for system in field 2*00). This is the

primary partition for the device. Enter 9 to make this keypad a "Master" keypad for the system.

Press [✱] to accept entry.

01 SOUND OPTION

If you entered device type 01 (alpha keypad), this prompt appears. Keypads can be individually

programmed to suppress arm/disarm beeps, entry/exit beeps and chime mode beeps. This helps prevent

unwanted sounds from disturbing users in other areas of the premises.

Enter a number 00-03 for the keypad sounding suppression options desired for the keypad as follows:

00 = no suppression

01 = suppress arm/disarm & entry/exit beeps

02 = suppress chime mode beeps only

03 = suppress arm/disarm, entry/exit and chime mode beeps

Press [✱] to accept entry.

01 KEYPAD GLBL?

If you entered device type 01 (alpha keypad), this prompt appears. Each keypad can give users with access

to multiple partitions the ability to arm and disarm those partitions from it. To enable this keypad for global

arming/disarming, enter 1. To prevent the ability to use this keypad for global arming/disarming, enter 0.

Press [✱] to accept entry.

01 AUI ?

1 = YES 0 = NO 0

Do Not Use. Must be set to “0”.

Press [✱] to accept entry.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 71 72

Komentarze do niniejszej Instrukcji

Brak uwag

ADEMCO VISTA-250FBP Instrukcja Konfiguracji Strona 32

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa ADEMCO VISTA-250FBP