ADEMCO VISTA-250FBP Instrukcja Konfiguracji Pobierz pdf (Strona 22)

– 22 –

Expert Mode Zone Programming

Expert mode allows you to program zones using the minimum number of screens and keystrokes.

Expert Mode Zone Programming does not provide the capability to program some of the zone’s attributes,

such as Arm w/Fault, Vent Zone, STAY mode, Auto-STAY, Bypass Group, etc. If you want to program a

zone for any of these attributes, you must use Zone Programming.

Enter the Programming mode with [Installer Code] + 8 0 0 0

Before programming your zones, do the following:

1. Program field 2✱00: Number of Partitions.

2. Enable your RF Receiver in

Device Programming

menu mode.

To program your zones, press ✱93 to display the "ZONE PROG?" prompt. Enter “0” (NO) to each prompt until the “EXPERT

MODE?” prompt appears.

PROMPT

EXPLANATION

EXPERT MODE?

1 = YES 0 = NO 0

Press 1 to enter Expert mode.

SET TO CONFIRM?

0 = NO 1 = YES 0

This prompt appears once upon entering Expert Mode.

If you select “Yes,” Confirmation prompts will be displayed after the device’s Serial and Loop numbers have

been entered later.

Zn ZT P RC In L

001 03 1 10 HW

A summary display appears, showing zone 1’s current programming or default values.

Zn ZT P RC In L

010 03 1 10 RF 1s

Enter the desired 3-digit zone number and press [✱].

NOTE: If you want to exit the Expert mode, enter “000” + [✱].

If an “s” appears after the loop number, it indicates that the transmitter’s serial number has been enrolled.

Use the [D] key to enter and duplicate wireless keys (see “Entering Wireless Keys” later)

Zn ZT P RC In L

010 03 1 10 RF

Enter all zone information except for Loop number, or press “C” to copy the zone information on this screen

from the last saved zone (including Loop).

ZT = Zone Type

P = Partition

RC = Report Code

In = Input Device Type

L = Loop number to which the sensor is connected.

NOTE: Pressing the [C] copies the zone information from the last saved zone, which includes the

input type. Verify this information is correct for this zone.

On this screen:

• Use the [A] key to move to the right.

• Use the [B] key to move to left and to back up to “ZT” field.

Press [✱] to accept the existing or newly-entered zone information.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 71 72

Komentarze do niniejszej Instrukcji

Brak uwag

ADEMCO VISTA-250FBP Instrukcja Konfiguracji Strona 22

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa ADEMCO VISTA-250FBP