ADEMCO Vista-20HW Instrukcja Naprawy Pobierz pdf (Strona 14)

100

Standard Phone Line Connections

Incoming phone line and handset wiring is connected to the main terminal

block (via a RJ31X jack) as follows (also see Figure 3):

Term. 21: Local Handset (TIP - Brown*)

Term. 22: Local Handset (RING - Gray*)

Term. 23: Incoming Phone Line (TIP – Green*)

Term. 24: Incoming Phone Line (RING – Red*)

* Colorsof wiresin DirectConnectCord.

Incoming ~

Handset

TelcoLine ~

IMPORTANT!

IF THE PANEL IS NOT CONNECTEDTO A PROPER

TERMINALS

ON CONTROL

21 22

W’L

EARTH GROUND, YOU MAY GET FALSETELEPHONE

23 24 25

LINE CUT INDICATIONS (IF THE TELEPHONE UNE

MONITOR HAS BEEN PROGRAMMED IN FIELD 92).

‘+&”K:::ELcoLINE

F&ure 3. Telephone be Connections

Wwing The AC Transformer

1321/TF2 Wire the 132UTF2 transformer to terminals 1 and 2 on the control board.

See wiring table below for wire gauge to use.

Caution must be taken when wiring the transformer to the control panel to

guard against blowing the fuse inside the transformer (the fuse is non-

replaceable).

4300 If you are going to use a 4300 transformer interface (required if Powerline

Carrier devices are going to be used), comect the 4300 transformer’s

terminals as follows:

a. Terminals 1,3 (AC), and 2 (Ground) to control board terminals 1,2, and

25, respectively (see Figure 5). See wiring table below for wire gauge to

use.

WIRING TABLE

Distance of Transformer Wire Gauge

Fkom the Control Panel

To Use

Up ta 50 feet

#20

50-100 feet

# 18

100-250feet

# 16

-14-

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 99 100

Komentarze do niniejszej Instrukcji

Brak uwag

ADEMCO Vista-20HW Instrukcja Naprawy Strona 14

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa ADEMCO Vista-20HW