Keypad Functions
Security Functions
Checking system status: STATUS (high level messages); press STATUS again for secondary messages.
To arm in STAY mode: Press and hold down STAY (or enter your code + STAY ).
To restart exit delay: STAY (applies only if system is armed in Stay mode and Quick Exit option has been enabled)
To arm in AWAY mode: Press and hold down AWAY (or enter your code + AWAY ).
To arm with NO DELAY: Press and hold down AWAY or STAY + NO DELAY or enter your user code + the keys shown).
To disarm the system and silence alarms: User Code + OFF .
Note: During Entry Delay or when an Alarm Condition exists the system can be disarmed by entering the User Code.
Entering the
OFF key is not required.
To bypass a zone(s): User Code + BYPASS + 2-digit zone number(s)
To turn Chime mode on or off: FUNCTION + CHIME
Message Center
To record a message: FUNCTION + RECORD
To stop recording before end of 85 seconds: OFF
To play back a message: FUNCTION + PLAY
To skip a message: [✴]
To delete all messages: FUNCTION + DELETE (during message replay)
Volume Control
To adjust message playback/system announcement volume: FUNCTION + VOLUME + [3] (Up) or [6] (Down)
To mute system announcements: FUNCTION + VOLUME + OFF
To restore/unmute announcements & volume: FUNCTION + VOLUME + [3] or [6]
Note: If the system was muted during Field Programming it will be unmuted upon exiting.
Other Functions
To set the time and date: User Code + FUNCTION + [63]
To activate or deactivate X10 devices 1-6: FUNCTION + LIGHTS ON or LIGHTS OFF + device number
To activate or deactivate X10 devices 7 & 8: User Code + [#] + LIGHTS ON
or LIGHTS OFF + dev. no.
To program scheduled events: User Code + FUNCTION + [64], then follow procedure in User Manual.
To add a User Code: Master Code + CODE + user number + User’s Code.
To delete a User Code (except Master Code): Master Code + CODE
+ user number
To turn Test mode on: User Code + TEST
To turn Test mode off: User Code + OFF
To use the defined AUX function: Press and hold AUX key 2 secs (4 beeps) + User Code
(To define the AUX function, refer to the procedure in the Aux Function section of the User Manual. Note: The 1-button
paging feature [field *87] is not enabled with the default programming)
To program Follow Me Reminder telephone number: User Code + FUNCTION + [65]
The Babysitter Code and Installer Code cannot disarm the system unless it was the code used to arm the
system. In addition, if the system is armed by pressing and holding the Quick-Arm buttons, neither the
Babysitter Code nor the Installer Code can disarm the system.
- 7 -
(4 strony)
(64 strony)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji