*81
ZONE LISTS FOR OUTPUT DEVICES – This is an interactive mode. Fill in the required data on the worksheet
below and follow the procedure in the installation manual as you enter the data during the displays and prompts that
appear in sequence.
Note: Record desired zone numbers below. More or fewer boxes than shown maybe needed, since any list may
include any or all of system’s zone numbers.
Zone List 1: Started or stopped by zone numbers (enter 00 to end entries).
❑ 0 ❑ 0, ❑ 0 ❑ 0, ❑ 0, ❑ n ❑ 0 ❑ 0 ❑ 0 ❑ netc
Zone List 2: Started or stopped by zone numbers (enter 00 to end entries).
❑ 0, ❑ n ❑ n ❑ n ❑ n, ❑ 0 ❑ n ❑ 0, ❑ 0 ❑ mtc
Zone List
3: Started or stopped by zone numbers (enter 00 to end entries).
❑ 0, ❑ 0 ❑ 0 ❑ 0, ❑ 0 ❑ 0 ❑ 0 ❑ 0 ❑ n, IIlnetc
SPECIAL MESSAGES
OC =
OPEN CIRCUIT (no communication between Console and Control).
EE or ENTRY ERROR= ERROR (invalid field number entered; re-enter valid field number).
After powering up, AC, dl (disabled) or System Busy and NOT READY will be displayed after approximately 4 seconds. This
will revert to READY in appx. 1 minute, which allows PIRS, etc. to stabilize. To bypass this delay, press: [#] + [0].
If E4 or E8 appears, more zones than the expansion units can handle have been programmed. Correct the programming and
then completely de-power and re-power the control to clear this indication and remove the disable indication.
TO ENTER PROGRAMMING MODE:
1.
2.
3.
POWER UP, then depress [*] and [#] both at once, within 50 seconds of powering
up.
OR
Initially, key Installer Code (4+ 1 + 1 +2) plus 8 + O + O.
OR
If different Installer Code is Droarammed. kev: New I nstaller Code + 8 + O + O.
(if *98 was used to exit previous~, method 1 ~bove must be used to enter the program mode again)
TO EXIT PROGRAMMING MODE:
*98 Exits programming mode and prevents re-entry by Installer Code + 8+ O + O. If *98 is used to exit programming
mode, system must be powered down, and method 1 above used to enter the programming mode.
*98 Exits programming mode and a//ows re-entry by Installer Code + 8 + O + O or: Power-up, then press “*” and “#”
within 50 seconds of power up.
-7-
(17 strony)
(56 strony)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji