ADEMCO 5130XM Instrukcja Obsługi Pobierz pdf (Strona 28)

SYSTEM CONFIGURATION (ZONES)

SETTING UP THE 4208

The 4208 is an 8 zone RPM which is connected directly to the polling loop.

Each zone is end-of-line-resistor supervised and can be used with either

open-circuit or closed-circuit devices. Zone numbers used with the 4208 are

pre-assigned in groups of 8 (except the first group) beginning with zone 10,

and are set via the unit%DIP switches. Note that if more than one 4208 is

used, the system limits the number of zones supported by the first group of

addresses to 7 (zones lo-16 available). If only one 4208 is used, the first

group of addresses can be expanded to 8 zones (zones lo-17 available) by

entering a 1 in program field ‘86. See the PROGRAMMING section tar

information regarding this programming option. See the PROGRAMMING

section for information regarding the use of more than one 4208.

The first two zones are DIP switch programmable for fast response (10

millisecond). Zones connected to this module are factory set for 400

millisecond response. The first six zones are high current zones for use with

mechanical sensors. The last two zones can support only low current sensors

(reed switches, etc.).

IMPORTANT!: The 4208 does not support P-wire smoke detectors.

NOTES:

PR?ZFAM

SWITCH

NOTES

LOOP 21

LOOP 3

LOOP 4 1

-0OP 5

4700 Ohms

A. Uses both sealed (reed) and unsealed (mechanical)

ContOctS.

F. Requires en external 36.660 Ohm end-o&line resistor (large. H watt.

8. Requires an external 4700 Ohm end-of-line resistor (small W watt.

ORANGE-BLACK-ORANGE color bands).

YELLOW-VIOLET-RED color bands).

G. Uses 100 microsmps 01 current each.

C. Selectable fast or slow response (both loops as a pair).

H. Make certain that the maximum current lrom the control’s polling

0. Uses 1 milliamp 01 current each.

loop is not exceeded.

E. Uses only sealed (reed) contacts.

1. If set for zones S-16. loop #l is lost on the 4206.

Diegmm 6. 4208 SUMMARY OF CONNECTIONS

ADEMCO’s VISTA XU SERIES TECHNZCAL REFERENCE MANUAL

WWW.DIYALARMFORUM.COM

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 158 159

Komentarze do niniejszej Instrukcji

Brak uwag

ADEMCO 5130XM Instrukcja Obsługi Strona 28

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa ADEMCO 5130XM