ADEMCO Vista 4130XT Instrukcja Obsługi Pobierz pdf (Strona 26)

Refer to Diagram 9 for Steps 8,9 and 10

8. Mount the Control as follows. Insert securing screw (previously

removed) in screw hole at front of Control (see Diagram 7) and

attach metal clip (at the rear) as shown in Diagram 9. Turn the

screw until the clip enters the guide point about % of an Inch (3 mm)

9, Insert the straight end of the flat spring into the slot at the other

side of the Control, as shown.

10, With the metal clip in the vertical position, mount the Control by

hooking the spring behind the right edge of the operwng so that It

holds the Control against the inside of the wall, as shown at (A), Now

turn the screw (from the front of the Control). The clip will turn until it

hits the clip stop and will then draw the Control forward (B). Continue

turning the screw until the Control is flush against the wall then, mak-

ing sure that the Control is straight, tighten the screw further to

secure the Control firmly in position. DO NOT OVERTIGHTENI

Insert the small VISTA XT nameplate supplied into the recessed

opening to cover the screw head at the front of the Control, as pre-

viously shown in Diagram 7.

WALL

OPENING

BATTERY BACKBOX

NOTE :

A ROUGH-IN RING (4133) MAY BE

PRESENT IN NEW CONSTRUCTION IF so,

SIMPLY REMOVE COVER PLATE TO

EXPOSE FRAMEo OPENING SUITABLE

FOR FLUSH MOUNTING OF THE CONTROL,

‘1

BACK’BOX

wsT”Os

~~, ,,

‘+. ‘“..

Diagram 8. WALL PREPARATION FOR FLUSH MOUNTING

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 83 84

Brak uwag

ADEMCO Vista 4130XT Instrukcja Obsługi Strona 26