ADEMCO VISTA-250FBP Instrukcja Konfiguracji Pobierz pdf (Strona 63)

Section 4 – Programming

4-9

Using a Relay to Unlock a Door

This control can be programmed so that a user can

trigger a relay for 2 seconds (e.g., to unlock a door) by

entering the User Code + [ 0 ].

To program a relay for this purpose, perform the

following steps:

Step Action

1 Enter Output Programming in the #93 Menu

Mode.

2 Program the output type as 1 or 2.

3 For type 1, program the ECP address and

relay number.

4 For type 2, program the house and unit codes.

Program the relay number in field 1∗76

(partition-specific).

NOTE: Cannot be used on partition 1 in

Commercial Fire installations.

See Output Programming in the Programming Guide

for a detailed explanation.

Programming for Communicator

• Program the communications device in Device

Programming in the #93 Menu Mode

Programming.

• Program field ✳56: Selects the time the panel

should wait before it attempts to send a message to

the second destination.

• Program field ✳57: Selects the initial reporting

destination for messages.

• Program field ✳58: Selects events for the primary

sub’s ID.

• Program field ✳59: Selects events for the secondary

sub’s ID.

• Program field 1✳70 Event Log Types (1=enable;

0=disable for each type).

• Program field 1✳71 12/24-Hour Time Stamp

Format (0=12 hr; 1=24 hr).

• Program field 1✳72 Event Log Printer On-line

(0=disable; 1=enable).

• Program field 1✳73 Printer Baud Rate (1=300;

0=1200).

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 135 136

Brak uwag

ADEMCO VISTA-250FBP Instrukcja Konfiguracji Strona 63