ADEMCO Accord Instrukcja Użytkownika Pobierz pdf (Strona 3)

NIGHT SET [3]

Night Set permits the user to set the system in selected areas, whilst others are unset,

e.g. unset in bedrooms whilst set in remaining rooms of house. This permits

freedom of movement in the secure environment.

To NIGHT SET the system:

1. Enter the User Code.

2. Press 3 (NIGHT SET).

No exit tone will sound during the exit period, however the DAY LED will flash as

the user passes detectors on the exit route. Two confirmation beeps indicate that the

system has set.

Note: To stop the system from setting during the exit period press Ö.

When the system has set, Ö will no longer function.

Press # + 3 (Night Set) to EASY SET the system, if available.

Unsetting the System

To UNSET the system:

1. Proceed to a keypad via the approved route and enter the User Code.

Resetting the System

To UNSET and RESET the system during or after an Alarm:

Entering a User Code will stop any alarm in progress. The zone LED causing the

initial alarm will then be displayed on the keypad. The User Code may be entered

again to reset the system.

If the panel has been programmed to accept only an Engineer Reset after an alarm

an Engineer Code is required to RESET the system.

A Technistore Reset is required if all the LEDs illuminate simultaneously followed

by a 5 digit series of numbers indicated by the LEDs lighting in sequence. This

code is given to the monitoring station to obtain an anti-code which can be entered

to RESET the system.

Note: If the system does not reset Contact the alarm company.

X: Zones which are active in each set mode.

ALARM SYSTEM SETTINGS

FULL

SET

PART

SET

NIGHT

SET

ZONE

1 2 3 4 5 6 7 8

Brak uwag

ADEMCO Accord Instrukcja Użytkownika Strona 3