IV. MOUNTING AND POWERING THE SYSTEM
Note that field wiring to these controls/consoles must be completed before the controls/consoles can be
mounted.
SURFACE MOUNTING
1.
Use the template provided. (on a separate
sheet) to mark the positions on the wall for the
screw mounting holes and the cut-out for the
wiring.
2, Pull the interface wiring in the wall through the
cut-out.
3. Remove the console’s back cover. The securing
screw at the front of the console must be removed
to release the back cover .
4. Pass the interface wiring through the opening
in the back cover and through the 4143 Expansion
Ring (if used), then mount the back cover to the
wall surface with screws.
5. Splice the interface wiring to the console wires
(or to the wires on the interface connector supplied
with 4137s). fnsulated solderless wire splices (eg.
311) may be used for splicing.
6. Attach the main body of the console to the
wall-mounted back cover. The console is properly
attached when it snaps into place. Use the securing
screw (previously removed) to secure the console
to
the back cover .
’
l-l&?- MIN (4 cm)
l
- 10 -
FLUSH MOUNTING WITH TRIM RING
1. Cut out a 4-314’ high by 8‘ wide opening in the
wall between studs, no less than t-112” from
either stud. Use the template provided to mark the
cut-out.
2. insert the four l-112’ long #6 screws through
the mounting bolos in the supplied Trim Ring and
then attach the four metal securing clips, as shown
in the diagram. Use only two or three turns of each
screw, allowing the metal clips to hang freely. The
clips must not protrude beyond the sides of the
Trim Ring or you will not be able to install the Trim
Ring into the cut-out in the next step.
3. Install the trim ring into the opening in the wall
with the hinge clasps to the right. Making sure the
trim ring is straight, tighten each clip screw,
making sure that the attached clip slides down into
its guide track.
4. Install the Console as follows: Engage the hinge
clasps on the trim ring with the notches located in
the back (right-hand side) of the Console’s front
panel. Swing the left side of the panel toward the
trim ring (the panel will pivot on the hinge clasps),
and press firmly until the panel ‘snaps’ closed.
5.
Use the panel securing screw (supplied with the
Console) to secure the left side of the panel.
MFlAL
SECURING
CLIP.
FOR ClAFmY.
ONLY ONE
cLlP.sHGwN
IN THIS
lLLUSlR4TlGN
HINGE CLASPS
WWW.DIYALARMFORUM.COM
(24 strony)
(56 strony)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji