ADEMCO 4160-12 C-COM Dokumentacja Pobierz pdf (Strona 49)

10.

Replace the receiveris cmer.

Comeeti~ and Settiogs:

Connect a 800d earth gromd (a cold water pipe or d ectrical box

grounding wfil seine this pu~ose in some locations) to the scrm

teminal marked EAR~ GROUND.

This scra is located on the lower

right

side of the NO. 685*s rear panel (see Diagram 2). This

connection will provide a ground path for the syst~ and must be

used.

Comect printer(s) and/or c~pntefi to the appropriatee connector(s)

prwided at the rear of the receiver.

Note:

Use of shielded cable betieen the No.

685 and the printer(s)

is recommended.

Not relmant to UL 864 Listed fire tiam monitoring.

If opti~ co-tire to the ~

AL= c~ector at the rear of

the receiver ia to be made (see Section III D 5), use the two

conductor cable ass~bly prowided, at this time, and cmplete this

portion of the comection procedure.

Set the switches in the DIP ~itch group ad the RRCS~ -RR

sdertor ~itch (locatedinside the flip-dwn pand on the face of the

receiver) in accordance with Sections 111 B and IIT C.

Open the

flip-down panel by palling on the hsndle.

Comect the AC line cord (prwionsly pluggd into the back of the

receiver) to the AC sourcefi.

The AC P~ER light on the face of the

receiver should fll~inte, the TI~ and DATS should appear on the

display (though not yet correctly act) and the receiverfs fan shodd

operate.

The AC source for the UL 864 Listed fire dam monitoring is the

wired-in receptaclein the 19-inch rack cabinet.

The sof~are rwision lmel shodd appear on the left display.

Plug both connectors frm the staod~ batteq cables (pr~iously

c~ected to the bstte~) to the B~ 1~ conectors at the rear of

the receiver.

Set the date snd ttie via the appropriate witches behind the

flip-d~n panel on the frent of the receiver, as described in Section

III C 5, 6, 7.

b-t the tdephme line(s) to the T~@ LI~S teminds at the rear

of the receiver, obseming polarity.

Polariq must be obsemad, to

dlw the receiver!sline fadt motitors to ope~te.

Polarity my be

detemined by placing a DC voltmeter (50-volt scale) temporarily

across tbe phone line.

If the meter reads upscale, the positive (+)

lead of the meter is comected to the positive (+) phone wire.

If the

meter reads dmnscale, the positive lead of the meter is connected to

the negative (-) phone wire.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 67 68

Komentarze do niniejszej Instrukcji

Brak uwag

ADEMCO 4160-12 C-COM Dokumentacja Strona 49

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa ADEMCO 4160-12 C-COM