ADEMCO 4160-12 C-COM Dokumentacja Pobierz pdf (Strona 38)

New alarm (channel status wde 1, per Table B) and restore

(statua code 3) conditions wfll be identified by zone (ZONE 1

ALA~ or ZONE 1 RESTORE for ebannel 1, etc.) titbcut s~cifying _,

the t~ of alarm or r=tore (fire,bur@ar, etc.)

OPEN~G (status code 2), ~OSMG (4), LOW BAT~RY (8) and ~T

(9) conditions will cause the appropriate message to be printed

as well as turn on the corresponding ~SAGE TYPE display UD

on the No. 685.

For emple, if a masage indicating a new ~srm on channel

2 is received (Receiver No. 1, Group No. 3, Acmunt No. 890),

the follming message wotid be printed:

12:30 ~ 01/01 13 0890 5155 5555 7 (V) ZONE 2 ALARM

If m~tiple reporting conditions occur, ofiy the En@ish language

for the most significant condition (lowest channel #) wfll be

printed; however, an (M) will k printed ahead of the En@ish

language message.

B. OpsratiM Options:

The following options can te selected during the pro@smming of the ,o@ion

PROM chip (No. 691) on the memory card, as described in Section VI C.

-W Lagua~ -ble:

As shipped, the En@ish lsn~age out~t is

disabled on dl 8 line =rds.

T~S OPTION ~ST BE USED TO ENAB~ Am

OR ALL LINE CARD2 TO PRODU~ ENGLEH LANGUAG~RI~OUTS. Hmever, any

line which receives non-standardized alarm codes shodd not be

enabled, @ess the ‘tine En@ishn option (see nest paragraph) is

used.

wZone ~isbw hble: This option is used to enable ‘Zone En@ish”

(descrikd in the previous section, VI A 2) on any or all No. 685 Line

Cards.

--t:

When this option is selected, the. En~ish Laguage

Enable (see option 1 stove) must dso be selected for

the s=e line esrd(s).

Reote ~ert Ddam

Utiess the Pulse Relay option is selected (see

option 8 helm), the operation of the No. 685’s rm~e ae* cOntac~

follows the No. 685’s internal dwt, after a user selectable delay of

up to 50 seeonds.

Mote:

Nsfimum &stance between the 685 Reeeiver and the remote

~ert somder is 50 feet.

w RZ*: When this option is selected, the No. 6851s clock and

c~endar wfil synchronize with a 50 Hz. AC power source,

instead of the standard 60 Hz (utilized outside of the

U.S.A.).

\–..

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 67 68

Komentarze do niniejszej Instrukcji

Brak uwag

ADEMCO 4160-12 C-COM Dokumentacja Strona 38

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa ADEMCO 4160-12 C-COM