- 2 -
Refer to the Installation and Setup Guide for detailed information on Programming the 4110XM. The Installation and Setup
Guide includes addition information on the data fields,
Entering Program Mode
Use one of the following methods to enter Programming Mode:
1. Power up, then depress both the [*] and [#] keys at the same time within 50 seconds after power is applied to
the Control.
OR
2. After power-up, enter the [Master Code] + 8 + 0 (default Master Code is 4110).
Note: This method is disabled if you exit the program mode using *98 instead of *99. See "Exiting Program Mode" later in this
section.
3. Upon entry into Program mode, data field *20 will be displayed (the first field in the system) and both keypad
LED’s will flash.
Programming Mode Commands
Task Command/Explanation
Go to a Data Field
Press [∗
∗∗
∗] + [Field Number], followed by the required entry.
Entering Data
When the desired field number appears, simply make the required entry. When the last entry for
a field is entered, the keypad beeps three times and automatically displays the next data field in
sequence. If the number of digits that you need to enter in a data field is less than the maximum
digits available (for example, the phone number fields *41, *42), enter the desired data, then
press [*] to end the entry. The next data field number is displayed.
Review a Data Field
Press [#] + [Field Number].
Data will be displayed for that field number. No changes will be accepted in this mode.
Deleting an Entry
Press [∗
∗∗
∗] + [Field Number] + [∗
∗∗
∗]. (Applies only to fields *40 thru *44, *94)
Initialize Download ID
Press ∗
∗∗
∗96. Initializes download ID and subscriber account number.
Reset Factory Defaults
Press ∗
∗∗
∗97. Sets all data fields to original factory default values.
Exit Program Mode with
installer code lockout
Press ∗
∗∗
∗98. Exits programming mode and prevents re-entry by: Installer Code + 8 + 0 + 0.
To reenter programming mode, the system must be powered down, then powered up. Then use
method A above. See field *88 for other 98 Program mode lockout options.
Exit Program Mode
Press ∗
∗∗
∗99. Exits programming mode and allows re-entry by: Installer Code + 8 + 0 + 0 or
method A above.
(68 strony)
(56 strony)
(16 strony)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji