ADEMCO Alpha Vista Console Instrukcja Użytkownika Pobierz pdf (Strona 29)

,-,

POWERING THE SYSTEM

AC POWER

The Ademco 1451 transformer with enclosure (supplied) is used to supply AC

power to the 5140XM panel. The 1451 consists of a transformer (with 120

VAC/1.0 Amp prima~, 18 VAC/72 VA secondary rating), and a manually

reseffable circuit breaker munted inside a protective enclosure.

Remove the front cover of the enclosure.

Mount the enclosure to the wall near the 5140XM panel. The enclosure has 4

mounting holes on ifs back sutiace for this purpose.

Run 120VAC wiring to the enclosure in conduit. NOTE: A dedicated circuit

must be used. Use wire nuts to splice the 120VAC wires to the transformer’s

white and black primary leads. Connect the eaflh ground post on the back of

the enclosure to a good earth ground (see EARTH GROUND

CONNECTIONS

kbW),

Use wire nuts to splice the transformer blue secondary leads to 16AWG wire

wtich is run in conduit to the panel. These wires are connected to panel

terminals 1 &2.

NOTE 1: Use wires having insulafiin rated for at least 90°C operation and

suitable for non-pawer fimfied applications.

NOTE 2: Use care to keep 18VAC wiring separated from all other wiring ins tie

the panel’s enclosure. This must be done by running non-power Iimfied

18VAC wiring into the panel’s enclosure via one of the knockouts on the left

hand side of the encbsure, and then tie wrapping these wires to the tie wrap

loops located near the knockout.

Replace the front cover of the enclosure and fasten with the screws supphed.

PANEL EARTH

Connect theeaflh ground post irrsidethe 1451 enclosure toagood earth ground

GROUND (use grounding methods specified inthe National Electric Code) .Runal6AWG

CONNECTIONS

wire from this post to the panel’s earth ground terminal (terminal 30), T~s method

of connection avoids ground Ioops that mayoccur when the 1451 and panel are

connected to different earth ground systems. NOTE: The panel requires this

connection in order for ~s lightning transient protection devices and eadh grouti

supewision to funcdon properly.

NOTE WHEN CONNECTING BAnER!ES IN PARALLEL

oUSE BA~ERIES FROM THE SAME MANUFACTURER

AND WITH THE SAME VOLTAGE AND CAPACIV MTING.

. USE BA~ERIES WITH APPROX1 MATELY SAME AGE AND

Hgure 19. BA~ERY CONNECTION DIAGRAM

BA~ERY TABS

.:= ‘1–

USE THE 2nd PAIR OF BA~ERY

TABS

ANDTHE 2nd PAIR OF

+ REO ~AnERy HARNESSE$S”ppL,ED

L-

TO CONNECT ONE OR WO

ADDITIONAL BA~ERIES IN

PAMLLEL

DUAL

BA~ERY

HARNESS

(2 PAIRS SUPPLIED)

MAIN PCB

OBSERVE POMRIN !

& ‘4c*k

-29–

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 73 74

Komentarze do niniejszej Instrukcji

Brak uwag

ADEMCO Alpha Vista Console Instrukcja Użytkownika Strona 29

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa ADEMCO Alpha Vista Console