ADEMCO 4111XM Instrukcja Użytkownika Pobierz pdf (Strona 2)

ADEMCO GROUP TECHNICAL SUPPORT KNOWLEDGEBASE

STEP -BY-STEP PROCEDURE

Created: 3.27.2000

Modified: 10.31.2001

File: V10se_23.Doc

Pages: 4

Page 2 of 4

10. Press “*” if the serial number entered is correct, the cursor should now be

flashing under the L. Enter the desired loop number for this device.

11. Press “*” to continue, if the confirm bit was set at the beginning of zone

programming the screen will display “XMIT TO CONFIRM PRESS * TO

SKIP” fault the device to confirm the serial number & loop number, otherwise

see step 12.

12. Press “*” to continue, screen displays “ZN ZT - RC IN : RT”

01 09 - 10 HW : 1

This is the ending summary screen & shows any changes made to this zone.

13. Press “*” to continue, screen displays “PROGRAM APLHA? 0 = NO , 1 = YES

0”. If you want to program alpha descriptors for this zone press 1 & refer to

adding descriptors document, otherwise press 0.

14. Screen displays “ENTER ZN NUM. (00 = QUIT) 11” & repeat steps 6-13 or

press 00 to exit the *56 menu mode, then press “*” + 99 to exit program mode.

15. To program zones using the expert mode press “*” + 58, screen displays “SET

TO CONFIRM? 0 = NO , 1 = YES” press 1 to confirm the serial number &

loop number for each zone.

16. Screen displays:

ZN ZT - RC IN : RT

01 09 - 10 HW : 1

NOTE: ZN = Zone Number

ZT = Zone Response Type

RC = Report Code

IN = Input Type

RT = Response Time

*Wireless Zones use zones 10-25.

17. The cursor should be flashing under ZN, enter the zone number you wish to

program then press the “*” key or press the “D” key to use a redesigned template

for the 5804/5804BD.

Loop Function Zone Type

1 No Response 23

2 Disarm 22

3 Arm Away 21

Template

1 (5804)

4 No Response 23

1 No Response 23

2 Disarm 22

3 Arm Away 21

Template

2 (5804)

4 Arm Stay 20

1 24Hr. Panic 07

2 Disarm 22

3 Arm Away 21

Template

3 (5804)

4 Arm Stay 20

1 2 3 4

Komentarze do niniejszej Instrukcji

Brak uwag

ADEMCO 4111XM Instrukcja Użytkownika Strona 2

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa ADEMCO 4111XM